Puch Mini Maxi Uživatelský manuál stáhnout pdf (Strana 14)

8.2 Parts List

RJ No

Footrest Bracket Assembly Left TSD8102

Right TSD8101

Footrest Stem 296/68

1/4 inch UNF Plain Nut zinc plated P91

1/4 x 7/8 inch UNF Hex head screw zinc plated F3

No 4 x 1/4 inch Self tapping screw zinc plated (not shown) 0456A

Spring (not shown) TSD1349 Bung

Footplate Assembly 8 1/2 inch complete with

Stem and Heel Loop Right M38RD

Left M38LD

Footplate Assembly 7 1/2 inch complete with

Stem and Heel Loop Right M37RD

Left M37LD Heel Loop Assembly

complete with nuts and washers SP327 Clamp Assembly

M102 Comprising:

Clamp Bolt F20

Clamp Nut F21

Clamp Washer F22

Spring TSD10080 Pivot

TSD11491 Latch Plate

TSD10072 End Bung

TSD2449

8.3 Inspection

Check that the footrest assembly locks into position.

Ensure that stem clamp holds footplate in position.

Ensure that footplate will remain in vertical position when required.

Ensure no sharp edges/burrs which could injure user.

8.4 Footrest Removal

Pull out the transit pin from the lower hinge pin.

Press the locking catch outwards and rotate the footrest assembly and lift upwards to remove.

Loosen the clamp with a 1/4 inch Whitworth spanner and slide the stem assembly out.

8.5 Footrest fitting

Re-assemble heel loop to footplate and tighten nuts to 10 lbs/ft (13.5Nm). Insert footplate stem

into hanger tube and tighten clamp to 35 lbs/ft (47Nm).

The footplate should remain in the vertical position when required. This is maintained by semi-

elliptic spring acting between footplate and pivot tube. This does not normally require maintenance.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Žádné komentáře

Puch Mini Maxi Uživatelský manuál Strana 14